Why is the sound very quiet on my Vision Speakers?
If the sound from your Vision Speakers is very quiet, ensure you are using shielded speaker cables with a gauge of 0.75mm or higher. Note that phono or minijack cables are shielded and not suitable for speaker connections.
What to do if sound is only coming out one side of my Vision SP-1800?
If sound is only coming from one side of your Vision Speakers, first, turn off the amplifier and switch the output connections. If the sound switches sides, the amplifier is working correctly, and the issue lies with one of the loudspeakers. If the problem persists, switch the input connections and check the input cabling.
Confirms Vision products comply with EU regulations, RoHS, and WEEE standards.
States that all Vision products are manufactured in the People's Republic of China (PRC).
Caution against removing covers and advises servicing by qualified personnel only.
Warns not to expose the appliance to rain or moisture to prevent fire or electric shock.
Avoid installing in moist, direct sunlight, extreme cold, or poorly ventilated locations.
Save original packaging for shipping in case of repair; damage in transit is not covered without it.
Speakers handle up to 50 watts RMS; compatible with amplifiers providing 10W-50W @ 8 ohms.
Position brackets over load-bearing studs and fix securely to wall or ceiling, ensuring level mounting.
Lower the loudspeakers onto the provided mounting brackets as illustrated.
Connect speaker cables from amplifier to screw terminals on rear using unshielded cable (0.75mm gauge+).
Set the desired angle for the speaker and lock the side screws to fix the position.
Diagnose sound problems by swapping connections or checking cable type and gauge.
Lists dimensions, weight, materials, technical details (power, impedance, sensitivity), and compliance.
Covers lifetime return-to-base warranty, conditions, limitations, and claim procedures.
To Next Page
General
