Vision Phoenix 1212 User Manual

Vision Engravers and Routers Installation Guide10
© 2015 Vision Engraving & Routing Systems
The computer's IP address will need to be set. NOTE - this should not cause any conflicts with your
computer's wireless IP address, which is determined by the computer's wireless network card. To set
the computer's IP address, open the Window's Control Panel. Depending on how you have this folder
set, you will either see Network and Internet, or you will see the Network and Sharing Center
immediately. If you see Network and Internet, select View Network Status and Tasks (which opens the
Network and Sharing Center). If you see the Network and Sharing Center, open it. Then select Local
Area Connection (as shown below).
Select Properties.

Vision Phoenix 1212 Specifications

General

Brand	Vision
Model	Phoenix 1212
Category	Engraver
Language	English