Vision Phoenix 1212 - Part II General Electrical and Facility Requirements; Part III Pendant Holder Installation

Vision Engravers and Routers Installation Guide34
© 2015 Vision Engraving & Routing Systems
2 General Electrical and Facility Requirements
Machine Model
Requirements
Phoenix 1212
One 110 VAC 15 Amp or One 220 VAC 10 Amp
Single Phase
Optional Equipment
Engraving Vacuum Chip Removal
System
One 110 VAC 15 Amp
NOTE: In addition to the above requirements, a 110 VAC standard outlet is required for the computer.
3 Pendant Holder Installation
Pendant Holder Installation for Phoenix 1212
Your machine is shipped with an optional Pendant Holder to give the user a place to secure the
Pendant.
To install the Pendant Holder on the Phoenix 1212, follow the below procedure.