Vision Phoenix 1212 User Manual

Vision Engravers and Routers Installation Guide20
© 2015 Vision Engraving & Routing Systems
The computer's IP address will need to be set. To set the computer's IP address, open the Window's
Control Panel. Depending on how you have this folder set, you will either see Network and Internet, or
you will see the Network and Sharing Center immediately. If you see Network and Internet, select View
Network Status and Tasks (which opens the Network and Sharing Center). If you see the Network and
Sharing Center, open it. Then select Local Area Connection (as shown below).
Select Properties.

Vision Phoenix 1212 Specifications

General

Brand	Vision
Model	Phoenix 1212
Category	Engraver
Language	English