User’s Manual
8
Learning Key
The receiver RCU has some learning keys at the upper part. The keys (except SET key) can be
used to memorize corresponding key values of TV RCU. After learning, you can realize remote
control for TV with the receiver RCU.
The recommended keys are TV POWER, TV/AV, VOL+ and VOL- of TV RCU. The identifier of
TV/AV key varies with different types of TV RCUs.
Instruction:
1. Keep pressing SET key on the receiver RCU for 3
seconds or more, the indicator status changes
from low light to high light, then stop pressing SET
key.
2. Press a learning key on the receiver RCU (such as
TV POWER key), indicator flashes slowly.
3. Aim the TV RCU at “receiving window” of the
receiver RCU, and press the corresponding key on
the TV RCU (such as TV POWER key) to learn.
The indicator flashes quickly, and then turns to
always bright, which means the learning is suc-
cessful.
4. Repeat steps 2 and 3 to set other learning keys in
the same way.
5. After setting, press SET key to exit, and indicator
is off.
If the operation fails, please try again according to
above steps.
Notes:
During setting, put the two RCUs on same horizontal surface and the space between
them should be within 5cm.
If there is no operation in 15 seconds, the receiver RCU will exit from learning mode
automatically.
You can operate the learning for times, but only the last one can be saved.
Some TV RCUs may not support this function.
To Next Page
Loading...
Need help?
General