User’s Manual
I
Safety Instruction
Read following items carefully before operating this receiver.
Installation
This receiver should be installed horizontally. Unbalanced installation may cause damage.
Install the receiver in a place with:
good ventilation (leave space not less than 10cm around this receiver)
no heat source (burning candle, radiator, heater, fireplace, amplifier, etc)
suitable temperature
against humidity (especially bathroom, kitchen, etc)
no direct sunlight
low vibration
Maintenance
Unplug this receiver from power socket before changing connections between this unit and
other related equipments.
Don’t unplug or insert signal, audio and video cables when this receiver is turned on.
To avoid the risk of lightning strike, unplug power cord of the receiver from power socket in
lightning storm.
Unplug power cord from power socket when the unit is not used for a long time or damaged
accidentally.
Turn off this unit first, after 1 to 2 hours turn it on when move this receiver from a cold
environment to a hot environment or vice versa.
To avoid the risk of fire or electric shock, don’t expose this receiver to rain, splashing and
don’t put object with liquid on this unit.
Do not cover vents of this receiver with newspaper, table cloth, curtain, etc.
Don’t put heavy objects on this receiver.
Unplug power cord of this receiver from power socket before cleaning. To reduce damage,
clean this unit with dry cloth. Do not let liquid and spray flow into this device to avoid seri-
ous damage.
There is dangerous voltage in product enclosure. Do not remove the cover (or back) to
avoid the risk of fire or electric shock.
Power Socket and Power Cord
Power socket should be available near the receiver and well grounded.
Do not insert or pull out power cord with wet hands to avoid electric shock or fire.
Do not use damaged power cord. If power cord is damaged, contact your local operator for
replacement to avoid risk of fire or electric shock.
Do not excessively bend power cord, and do not place heavy objects on it, which could
cause damage, electric shock or fire.
RCU Battery
Batteries should be installed in accordance with the polarity markings (+/-) on battery
compartment.
Remove batteries if RCU is not used for a long time.
To Next Page
Loading...
Need help?
General