Advent Communications
209297 – DCU5000 Drive Control Unit Page 38 of 42
A. Check, using a radiation hazard meter for RF leakage from all waveguide
flanges. These must not exceed currently accepted safe microwave radiated
levels.
B. Check for any a typical heating of waveguide components, using a Temperature
Probe and Digital Volt Meter (waveguide load will get hot during operation, but
interconnections should not).
C. When transmitting through the antenna system, check that spurious radiations at
rear and sides of the antenna and outside the coned areas do not exceed
currently accepted safe microwave radiated levels. DO NOT PROCEED UNTIL
ALL MEASUREMENTS ARE CORRECT.
To Next Page
Loading...
Need help?
General