Advent Communications
209297 – DCU5000 Drive Control Unit Page 6 of 42
4.32. F31: HHC OVERIDE ACTIVE 17
4.33. F33: FIN 1 OVER TEMPERATURE 17
4.34. F34: FIN 2 OVER TEMPERATURE 17
4.35. F35: FIN 3 OVER TEMPERATURE 17
4.36. F36: FIN 4 OVER TEMPERATURE 17
4.37. F37: FIN 5 OVER TEMPERATURE 17
4.38. F38: WGS POWER SUPPLY ALARM 17
4.39. F39: FAN POWER SUPPLY ALARM 18
4.40. F40: BRAKE POWER SUPPLY ALARM 18
4.41. F41: FEED POWER SUPPLY ALARM 18
4.42. F42: GPS/COMPASS POWER SUPPLY ALARM 18
4.43. F43: STATUS POWER SUPPLY ALARM 18
4.44. F44: AZ BRAKE DISCONNECTED 18
4.45. F45: EL BRAKE DISCONNECTED 18
4.46. F46: POL BRAKE DISCONNECTED 18
4.47. F47: AXIS 4 BRAKE DISCONECTED 18
4.48. F48: AXIS 5 BRAKE DISCONNECTED 18
4.49. F49: MAIN UNIT FAN SERVICE 18
4.50. F50: HEATSINK FAN SERVICE 18
4.51. F51: E
2
PROM CHECKSUM ERROR 18
4.52. F52: SOFTLIMIT DATA ERROR 18
4.53. F53: WOODED AREA DATA ERROR 19
4.54. F54: CAL. AREA DATA ERROR 19
4.55. F55: FPGA COMPATIBILITY WARNING 19
4.56. F56: EXT FLASH ERROR 19
4.57. F58: HEATSINK FAN STALL DETECTED 19
4.58. F59: HMR3300 TEMPERATURE WARNING 19
4.59. F60: HMR3300 TEMPERATURE ALARM 19
4.60. F61-F64 ALARM ERROR 19
5. REMOTE CONTROL 20
5.1. INTRODUCTION 20
5.2. SET UP 20
5.3. PACKET STRUCTURE 20
5.4. COMMANDS, QUERIES AND RESPONSES 21
5.5. REMOTE COMMANDS 23
6. MAINTENANCE & FAULT FINDING 37
6.1. PERIODIC MAINTENANCE 37
6.2. ELECTROSTATIC SENSITIVE DEVICES (ESD!) 37
6.3. TEST/ALIGNMENT OF UNITS FITTED WITH AC/DC POWER SUPPLY 37
6.4. SATELLITE TRANSMISSION EQUIPMENT 37
7. WARRANTY 39
7.1. WARRANTY INFORMATION 39
7.2. CLAIM FOR DAMAGE IN SHIPMENT 39
7.3. FIELD SERVICE 39
7.4. SHIPMENT OF REPAIR PARTS TO FIELD 39
7.5. RETURN PROCEDURES 39
7.6. TRANSPORTATION AND PACKAGING 40
7.7. AUTHORISATION FOR EVALUATION 40
8. FIGURES 41
FIGURE 1 – DCU5000 LAYOUT 42
To Next Page
Loading...
Need help?
General