3.7 PowerLink3 Installation
The PowerLink3 is used to view and control the PowerMaster-33 system over the Internet.
To install the PowerLink3, complete the following steps:
Note: PowerLink3 operation is not backed up by
the control panel’s battery and it is shut down
during AC failure.
1. Mount the internal PowerLink3 into the back
panel and fasten it with 2 screws.
2. Connect the flat cable (B) from the front panel
to the PowerLink3, as follows: Connector B1
to the front panel; connector B2 to the
PowerLink3.
3. Connect the Cat-5 cable from the PowerLink3
to the home router.
Note: In order to prevent interference to the
PG2 antenna, do not route the Cat-5 cable
through the cable entry knockout on the right
side of the panel.
A. Cat-5 cable to home router
B. Flat cable
B1. This side for front panel
B2. This side for PowerLink3
To Next Page
Loading...
