Visonic POWERMAX+ - 2.13 Disarming and Stopping Alarms

DE5465 9
APPENDIX A. Detector Deployment & Transmitter Assignments
A1. Detector Deployment Plan
Zone
No.
Zone Type Sensor Location or Transmitter Assignment
(in non-alarm or emergency zones)
Chime
(Yes / No)
Controls PGM
(X = YES)
Controls
X-10 Unit No.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29 (*)
30 (*)
Zone Types: 1 = Interior follower < 2 = Perimeter < 3 = Perimeter follower < 4 = Delay 1 < 5 = Delay 2 < 6 = 24 h
silent
< 7 = 24 h audible < 8 = Fire < 9 = Non-alarm < 10 = Emergency < 11 = Gas < 12 = Flood.
Zone Locations: Note down the intended location for each detector. When programming, you may select one of 26
available zone names (plus 5 custom zone names that you can add - see Figure 3 in the Programming Guide - Define
Zones).
* Zones 29 & 30 only are hardwired zones.
A2. Keyfob Transmitter List
Transmitter Data AUX button Assignments
No. Type Holder Status or Arming “instant” PGM Control X-10 Unit Control
1
2
3
4
Mark the boxes of the X-10 units to be
activated - see Section 7 in the programming
guide.
5
Indicate the desired function
(if any) – see par. 4.17 (Aux
button) in the programming
guide.
Indicate whether
this output will be
activated or not –
see Section 7 in the
programming guide
1
F 2 F 3 F 4 F 5 F
6
System status
F Yes F No F 6 F 7 F 8 F 9 F 10 F
7
Arming “instant”
F 11 F 12 F 13 F 14 F 15 F
8