APPENDICES
D-302542 39
Common Area Type
Definition
• Acts as a Delay type when at least one of the assigned partitions is
armed HOME.
• Will be ignored when at least one of the assigned partitions is
disarmed.
7
Emergency,
Fire,
Flood,
Gas,
Temperature,
24-hour silent,
24-hour audible,
Non-alarm
Always active.
Show Function
The show function is enabled during single/all
partition(s) status and displays information that is
relevant to the selected or all partitions.
Show All Partitions
In Ready mode press
, the display will
show information on all partitions. Press
repeatedly to view memory / status content.
Show Single Partition
In Ready mode, press
and then press the
partition number. The display will show information
relevant to the selected partition. Press
repeatedly to view memory / status content
Note: After 5 seconds of no button press there will
be a timeout and the display will revert to the all
partition display.
Selecting a Partition
When operating in partition mode the first display will
read:
P1: R P2: N P3: R
Press ; the display will read:
SELECT PARTITION
Press , and to select the desired
corresponding partition.
Note: After 5 seconds of no button press there will
be a timeout and the display will revert to the All
Partition display.
Siren
The siren is a common device to all partitions;
therefore, an alarm from one or more partitions will
activate a siren.
Siren Activity
• The siren will be activated when receiving an
event from an alarmed device.
• Overlapping activated sirens from different
partitions will not cause the siren active period
to be reset.
• When there are several zones that are not
assigned to a common area and that are
alarmed in two or more partitions, the siren will
not stop until all partitions assigned to the
alarmed zones are disarmed.
• In case that the siren is active by an alarm from
a common area, and one of the partitions
assigned to this area disarms the system, the
siren will stop.
• In case that the alarm is initiated from a
common area but continues with zones that are
not assigned to a common area, the siren will
not stop until all partitions assigned to the
alarmed zones are disarmed.
• In case that there is a fire in partition 1 and a
burglary in partition 2, the siren will sound FIRE.
When partition 1 is disarmed the siren will
sound BURGLAR for the remainder of the siren
timeout period.
To Next Page
Loading...
