TRUGOLF
18 19
VISTA 10/12
OVERHEAD LIGHT INSTRUCTIONS
INSTALLATION
1. Push the top portion of the head adapter into the slot of the track
section.
2. Pull down the adapter’s locking tab.
3. Turn “Ground Indicator” tab towards the ground groove on track to align
ground tab with ground conductor.
4. Move adapter to the end of the track closest to the HItting Mat. Aim
the lighting xture at the club head sensors.
REMOVAL
1. Pull down the adapter’s locking tab.
2. At the same time, rotate the adapter 90 degrees and remove from track.
CLONE DISPLAYS
There are two methods to set up multiple monitors in Windows 7. Make
sure that you connect the external monitors to your laptop or your desktop
computer rst.
METHOD 1:
1. Press the Windows logo key + P on your keyboard.
2. Select the DUPLICATE option
METHOD 2:
1. Right-click any empty area of your desktop, and then
click Screen resolution.
2. Click the Multiple displays drop-down list, and then select
Duplicate these displays.
Note: If you cannot see the additional monitor(s) listed, click
Detect. If does not work, try restarting your computer and do
step 1 to 2 again.
CAUTION: Refer to the re-lamping label located on the xture for recommended
maximum wattage. Adapter is designed to lock into the track section by
turning adapter in one direction only. Turn the “ground indicator” tab
towards the “ground groove” on the track to align the ground tab with the
ground conductor inside the track.
INSTALLING NEW BULB OR RE-LAMPING
1. Turning the power o. Make sure that the bulb is cool before re-lamping
the xture.
2. Remove the head from the track. The track head sleeve must be pulled
down then twist 1/4 turn.
3. Twist to remove bulb from the socket, replace with new bulb.
4. Replace the track head onto the track. Pull down the locking sleeve and
reverse the 1/4 turn.
OVERHEAD LIGHT MUST ME POSITIONED TO LIGHT THE 3 ROWS OF SENSORS
ON THE HITTING MAT. OVERHEAD LIGHT MUST BE ON WHILE PLAYING.
+
To Next Page