3.5. Downloading saved results
The test session may be transmitted to Vitalograph Reports on your
PC to be stored as a PDF le and viewed or printed.
Vitalograph Reports must be installed and running on the PC before
data is transmitted. The software is running if the Vitalograph ’V’
icon shows in the PC System Tray. If not, refer to help button of the
software for more information. Connect the COPD-6 USB device to
the PC using the USB cable to allow communication, see Figure 4.
Drivers should automatically install.
Figure 4. Attached USB cable.
1. Run Vitalograph Reports.
2. If ‘No devices have been detected’ message appears, click
‘Continue’.
a. Turn device on, .
b. In Vitalograph Reports ensure ‘Vitalograph COPD-6’ is
selected via the Device Selection Button
3. To print test results from the COPD-6 USB:
When the device is ready for age entry, press button
for 3 seconds for the last saved session. Use the or
To Next Page
Loading...
