7
• Avoid using bagged ice that has been stored in a freezer at extremely low temperature.
Use of this type of ice may result in freeze-up of the shaver. When you must use
bagged ice, it should be stored in an ice chest for a least an hour before use.
Replace the Ice Bin Lid and your machine is ready for use.
Ice Bin Lid
NOTE: For the Ice Shaver to work the Ice Bin Lid must be positioned
properly on top of the Ice Bin.
Each time ice is added to the Ice Bin or when the Ice
Bin is cleaned the lid must be replaced properly or the
machine will not shave ice. A safety interlock switch is
located on the Ice Bin and is deactivated when the lid
is placed in its correct position on top of the bin.
1. When replacing the lid align the mark on the front
of the lid with the mark on the ice bin.
2. With both hands press down on two sides of the lid.
3. Check to make sure the back of the lid is flush with
the lip of the Ice Bin.
Container Two-Piece Lid Assembly
The Two-Piece Lid is used when cleaning the container
or using the PBS as a variable speed blender only.
(See page 11 for instructions on using the PBS as a
variable speed blender.)
The Two-Piece Lid is easy to clean and easy to put
on and take off. (
NOTE: Brand new lids are a little
stiff. This is temporary.)
• The lid has a continuous rim which latches inside
the container tabs. Push one side of the rim under
one tab, and with the heel of your hands push down,
over the opposite tab, to snap lid into position.
• To remove lid, place hands around the lid, pressing
thumbs above one of the container tabs. Push in
and lift off.
• Twist the center Lid Plug to fasten or remove.
Container Pad
Make sure the Container Pad is positioned correctly by firmly pressing down on all four sides.
Do not remove the container pad unless it is damaged. See page 20 for cleaning
around the Container Pad.
For instructions on using the Control Panel turn to page 8.
For Operating Instructions turn to page 10.
To Next Page
Loading...
