Vitrum Clima - General Introduction; Product and Functional Overview

4
SIMPLY INIMITABLE.
1. General Introduction
This manual is intended to be used by installers
and describes functions and parameters of the
device VM_IPxxAxxKNX and how is possible to
change settings and congurations using ETS
software tool.
This manual is intended to be used by installers
and describes functions and parameters of the
device VM_IPxxAxxKNX and how is possible to
change settings and congurations using ETS
software tool.
2. Product and functional overview
VM_IPxxAxxKNX module is designed to be
installed in Home and Building installations (i.e.
oces, hotels, private houses, etc...).
The module includes ve capacitive touch
buttons.
The capacitive buttons can be used to on/o
commands, dimming, shutter control, scene
recall and control, sequences of 3 objects.
The VM_IPxxAxxKNX can manage one zone
thermoregulation with its temperature probe
and/or with one KNX temperature probe (with
On/O threshold) or one thermostats to control
heating and cooling equipments, valves, 2 and 4
pipes fan coils; etc..
The VM_IPxxAxxKNX can be also used as
Control Panel.
Capacitive buttons main functions:
• 1 bit commands: load activation /
deactivation commands (ON/OFF/TOGGLE) with
short press or with dierentiation of long and
short press
• 1 byte commands (unsigned 0-255 or HVAC commands or
value % commands).
• Sending of long action telegrams on the same address of
short action or on a dierent group address
• Cyclic sending
• Sequences (3 commands mixing 1bit/1byte objects) with
dierent group addresses
• Edges for 1 bit / 1 Byte / sequences
• Dimmer management (with single or double push-button)
• Blind / Roller Shutter management (with single or double
push-button)
• Scene management
• Thermostat management
Device congured as Temperature sensor - main functions:
• 2 dierent temperature thresholds to trigger 1 bit telegrams
alarm/warning
• Enable / disable of alarm / warnings via 1 bit object
Congured as Thermostat - main functions:
• Dierent control algorithms: 2 point on/o; PWM;
Continuous Control / Fan Coil Control
• Dierent setting modes: via HVAC automatic / via HVAC
Manual / via Setpoint
• Window contact function
• Additional external temperature sensors (optional)
Congured as Control Panel Main function
• Display the actual temperature or actual setpoint
• Permit to control a remote KNX thermostat
• Additional external temperature sensors (optional)