Thank you for purchasing VITAC 200
▶
Please make sure to read all safety precautions thoroughly before using this product for proper use of the product.
▶
Please provide this user manual to end users and maintenance manager.
▶
Please keep this manual in a place where users can easily refer to at any time, after reading this manual.
▶
Please follow safety precautions to prevent any accidents or risks by using the
product safely and properly.
▶
Precautions are grouped into two types - “Warning” and “Caution”
1. Do not perform wiring work when power is supplied or the product is in operation.
2. There is always a dangerous level of voltage in the terminal that connects digital input, power,
and external I/O circuit power when operating normally.
3. Be sure to follow standard safety precautions while installing or maintaining the product.
4. General users should not access the terminal after product installation.
1. The product may be seriously damaged if the voltage/current that deviates from the power
supply input rating is applied.
2. Do not allow screws, metal objects, water, or oil to get inside the product.
3. Observe the rated load specifications of the input and output contacts.
4. Do not wire the cable at your own discretion.
5. Only qualified electricians are allowed to perform wiring, trial operation, and maintenance.
6. Do not run a withstand voltage test because all external terminals including the product power
plug are equipped with a withstand voltage protection device.
Safety Precautions
Warning
▶
In case severe injuries or death takes place when violating the instructions.
Warning
※
Please read this manual carefully before using the product to ensure that the functionality of this product is used fully and safely.
Caution
▶
In case minor injuries or product damage takes place when violating
the instructions.
Caution
To Next Page
Loading...