16
ScreenRunning
Voltage information: make sure your screen is working at the , depending on the area.correct voltage
(2) When the product power is turned on, a "beep" sound will be emitted for 1.5 seconds, indicating that the
product has been powered on.
(Using the wrong voltage may cause the screen to become inoperable)
(1) Plug the screen power cord into the correct power outlet.
(3) When the screen is fully raised, you can choose to turn off the power switch and unplug the power cord due to
long-term viewing. At this time, the screen will remain open and will not be closed due to power off. To turn off
the screen, connect the power cord and turn on the switch to resume operation.
Note: when the screen is raised, make sure there is no obstacle and enough space on the top of the screen, and
do not put your head on the top of the screen to avoid personal injury and product failure.
(4) When the left power switch is powered on, you can use any of the methods described below to run the screen.
To Next Page
Loading...