DLP Projector—User’s Manual
Command Control Settings
Press the ENTER button to enter the Command Control Settings sub menu.
ITEM DESCRIPTION
Control By Press the ◄► buttons to select projector remote command control. (Range: RS232/ RJ45)
Network State
Press the ENTER button to enter the Network State sub menu.
See Network State on page 30.
Projector ID
Press the cursor ◄► button to set Projector ID number for projector control by RS232 com-
mand.
Network State
ITEM DESCRIPTION
Network State Displays the network connection status.
DHCP
Press ◄► to turn DHCP On or Off.
Note: If you select DHCP Off, complete the IP Address, Subnet Mask, Gateway, and DNS
fields.
Projector IP Address Enter a valid IP address if DHCP is turned off.
Subnet Mask Enter a valid Subnet Mask if DHCP is turned off.
Default Gateway Displays the default Gateway address on the network.
DNS Enter a valid DNS name if DHCP is turned off.
Apply Press (Enter) / ► to confirm settings.
— 30 —
To Next Page
Loading...
Need help?
General
