DLP Projector—User’s Manual
SETUP>>Advanced Menu
Press the MENU button to open the OSD menu. Press the cursor ◄► button to move to the
SETUP>>Advanced menu. Press the cursor ▲▼ button to move up and down in the
SETUP>>Advanced menu.
ITEM DESCRIPTION
Audio Press the ENTER button to enter the Audio sub menu. See Audio on page 35.
Lamp Press the ENTER button to enter the Lamp sub menu. See Lamp on page 35.
HDMI Press the ENTER button to enter the HDMI sub menu. See HDMI on page 36.
High Altitude Mode
Press the cursor ◄► buttons to turn on or off High Altitude Mode.
Recommended to turn on when the altitude of the environment is higher than 1500m (4921ft).
Test Pattern Press the cursor ◄► buttons to select test pattern.
Closed Caption
Press the ENTER button to enter the Closed Caption sub menu.
See Closed Caption on page 36.
LED Control
Press the cursor ◄► buttons to select the LED control.
Select Normal for normal LED display and Off to disable LED display.
Presentation Timer Press (Enter) / ► to the Presentation Timer menu. See Presentation Timer on page 37.
Low Power Mode
Press the cursor ◄► buttons to set Low Power Mode on or off.
Note:
When Low Power Mode set to off, VGA OUT terminal can output signal during projec-
tor in Standby mode.
Low Power mode will be gray out, when command control is setting to RJ45.
Reset All Press the ENTER button to enter reset all settings to default values.
— 34 —
To Next Page
Loading...
Need help?
General
