VIVOTEK
124 - User's Manual
If you enable adaptive recording on Camera A, only when an event is triggered on Camera A will the
server record the streaming data in full frame rate; otherwise, it will only request the I frame data during
normal monitoring, thus effectively save lots of bandwidths and storage.
The alarm trigger includes: motion detection and DI detection. Please refer to Event settings on page 99.
■ Pre-event recording and post-event recording
The Network Camera has a buffer area; it temporarily holds data up to a certain limit. Enter a number
to decide the duration of recording before and after a trigger is activated.
■ Priority: Select the relative importance of this recording (High, Normal, or Low). Recording with a higher
priority setting will be executed rst.
■ Channel # Stream #: Select a channel and a stream under it as the recording source.
► To enable adaptive recording, please also enable time shift caching stream and select a caching
stream on Media > Video > Stream settings. Please refer to page 57 for detailed instruction.
► To enable recording notication please congure Event settings rst. Please refer to page 99.
Time
Bandwidth
Bandwidth
Activity Adaptive Streaming
for Dynamic Frame Rate Control
I frame ---> Full frame rate ---> I frame
Continuous recording
► To enable adaptive recording, please make sure
you’ve set up the triggering sources such as Motion
Detection, DI Device, or Manual Trigger.
► When there is no alarm trigger:
- JPEG mode: record 1 frame per second.
- H.264 mode: record the I frame only.
► When the Intra frame period has been set to larger
than >1s on Video settings page, the Intra frame
period will be forced into 1s when the adaptive
recording is activated.
NOTE:
NOTE:
■ Recording name: Enter a name for the recording setting.
■ Enable this recording: Select this option to enable video recording.
■ With adaptive recording:
Select this option will activate the frame rate control according to alarm trigger. The frame control
means that when there is a triggered alarm/event, the frame rate will raise up to the value you’ve set
on the Stream setting page. Please refer to page 57 for more information.
To Next Page
Loading...
Need help?
General
