Vivotek FD816C-HF2 - Page 262

VIVOTEK
262 - User's Manual
tiltspeed -5 ~ 5 1/7 Tilt speed
(It should be set by eCamCtrl.cgi rather than by
setparam.cgi.)
panspeed -5 ~ 5 1/7 Pan speed
(It should be set by eCamCtrl.cgi rather than by
setparam.cgi.)
zoomspeed -5 ~ 5 1/7 Zoom speed
(It should be set by eCamCtrl.cgi rather than by
setparam.cgi.)
autospeed 1 ~ 5 1/7 Auto pan/patrol speed
(It should be set by eCamCtrl.cgi rather than by
setparam.cgi.)
rotatespeed 1 ~ 5 1/7 Rotate speed (only for Fisheye series)
* Only available when "capability_fisheye" is 1
and "capability_fisheyelocaldewarp_c<n>" is 0
(It should be set by eCamCtrl.cgi rather than by
setparam.cgi.)
Group: eptz_c<0~(n-1)>_s<0~(m-1)> for n channel product and m is the number of streams which support
ePTZ. (capability.eptz > 0)
PARAMETER VALUE SECURITY
(get/set)
DESCRIPTION
patrolseq string[120] 1/4 The patrol sequence of ePTZ. All the patrol
position indexes will be separated by ","
patroldwelling string[160] 1/4 The dwelling time (unit: second) of each patrol
point, separated by “,”.
preset_i<0~19>_name string[40] 1/7 Name of ePTZ preset.
(It should be set by ePreset.cgi rather than by
setparam.cgi.)
preset_i<0~19>_pos <W,H>
<product dependent>
1/7 Left-top corner coordinate of the preset.
(It should be set by ePreset.cgi rather than by
setparam.cgi.)
preset_i<0~19>_size <WxH>
<product dependent>
1/7 Width and height of the preset.
(It should be set by ePreset.cgi rather than by
setparam.cgi.)