VIVOTEK
372 - User's Manual
8.31 SmartSD (capability_localstorage_smartsd > 0)
Note: This request requires Administrator privileges.
Method: GET/POST
Syntax:
http://<servername>/cgi-bin/admin/smartsd.cgi?function=<value>
PARAMETER VALUE DESCRIPTION
function getstatus Function type
getstauts : Information of smartSD internal status return value as
below:
smartsd_lifetime_num:
Accumulated amount of data that has been written
smartsd_lifetime_den:
Card-guaranteed amount of data that can be written
smartsd_lifetime_rate:
The ratio of smartsd_lifetime_num to smartsd_lifetime_den.
It means the accumulated percentage amount of flash block has been
written. The range is from 0 to 100 (unit: %). The SD card is
recommended to be replaced if the percentage reaches above 90%.
smartsd_spare_block_rate:
Usage rate of spare blocks.
It means the usage percentage of total spare block. The range is from
0 to 100 (unit: %). The SD card is recommended to be replaced if the
percentage reaches above 90%.
smartsd_data_size_per_unit:
Size (in sectors) of data to be written when Life Information1 is
updated.
smartsd_num_of_sudden_power_failure:
Indicates how many times power disconnection occurred during
write/erase operations
smartsd_operation_mode:
Enables/disables power-off detection and write error notification
smartsd_attached:
Indicate the smartSD is attached or not.
To Next Page
Loading...
Need help?
General
