Vivotek FE8180 - Anystream Access Configuration

VIVOTEK
User's Manual - 213
Return Code Description
400 Bad Request Request is rejected because some parameter values are illegal.
415 Unsupported Media Type Returned, if forcechk appears, when minsft is not achievable or the
timeshift feature of the target stream is not enabled.
8. 25 Open Anystream (capability.nanystream > 0)
Note: This request requires Viewer access privileges.
Syntax:
For HTTP push server (MJPEG):
http://<servername>/videoany.mjpg?codectype=mjpeg[&resolution=<value>&mjpeg_quant=<value>&mjpeg
_qvalue=<value>&mjpeg_maxframe=<value>]
For RTSP (H264), the user needs to input the URL below into an RTSP compatible player.
rtsp://<servername>/liveany.sdp?codectype=h264[&resolution=<value>&h264_intraperiod=<value>&
h264_ratecontrolmode=<value>& h264_quant=<value>& h264_qvalue=<value>& h264_bitrate=<value>&
h264_maxframe=<value>]
<product dependent>
PARAMETER VALUE DEFAULT DESCRIPTION
codectype mjpeg, h264
<product dependent>
N/A Set codec type for Anystream.
solution capability_videoin_resolution <product
dependent>
Video resolution in pixels.
mjpeg_quant 0, 1~5
99, 1~5
<product dependent>
3 Quality of JPEG video.
0,99 is the customized manual
input setting.
1 = worst quality, 5 = best quality.
<product dependent>
mjpeg_qvalue 10~200
2~97
<product dependent>
50
<product
dependent>
Manual video quality level input.
(This must be present if
mjpeg_quant is equal to 0, 99)
<product dependent>
mjpeg_maxframe 1~25,
26~30 (only for NTSC or
60Hz CMOS)
15 Set maximum frame rate in fps (for
JPEG).
h264_intraperiod 250, 500, 1000, 2000, 3000,
4000
1000 Intra frame period in milliseconds.