VIVOTEK
User's Manual - 51
If you want to configure another sensor setting for day/night/schedule mode, e.g., a different image
configuration for a different period of time, please click Profile to open the Profile Settings page as
shown below.
Please follow the steps below to setup a prole:
1. Select the Enable and apply this prole checkbox.
2. Select the applied mode: Day mode, Night mode, or Schedule mode. Please manually enter a range of
time if you choose Schedule mode.
3. Congure the White balance and Image adjustment settings in the following columns. Please refer to the
previous page for detailed information.
4. Click Save to enable the settings and click Close to exit the page.
2011/03/13 17:08:56
To Next Page
Loading...
