Vivotek IB8360-W User Manual

VIVOTEK
User's Manual - 9
IMPORTANT:
WPS Button Usage
Function LED Behavior
- White - operating in AP mode (default status).
Reset - press less than 3 seconds, Off then Red, then White.
WPS - press 3 to 5 secs, Flashing Blue for 2 mins, then Red, then Green.
Restore default - press longer than 7 secs. Flashing Red and Green
LED Color Indication
Steady Red Power on and system booting
All LED off Power off
Blink Red / Green every 0.15 sec Upgrading F/W
Blink Orange every 0.15 sec Restoring default
Blink Green every 1 sec Wireless AP linked
Blink Blue every 0.15 sec WPS searching
Blink White every 0.5 sec Operating in AP mode
Steady Red Network Failed
Blink Red / Green every 1 sec Connected to network
Refer to the functional description and LED denitions below when conguring the camera.
5. Connecting to network. There are 3 different ways to connect the camera to a wireless
network.
A-1
A: WPS
A-1. Press the WPS button for 3 to 5
seconds. You may need to use your
nger nail to press.
A-2. Press the WPS button on your
wireless AP (router). Some router/
AP have a virtual button on their
management software instead. Refer
to your AP's documentation for details
using its WPS function.
When WPS conguration is done,
wireless connectivity will be established
and the security encryption, such as
WEP or WPA-PSK, will be synchronized
with the AP. Install and use VIVOTEK's
IW2 utility to nd the camera. By default,
the camera's rmware uses the DHCP
client mode.
LED Denitions
WPS
AP
WEP or WPA-PSK
3 ~ 5secs
WPS

Vivotek IB8360-W Specifications

General

Brand	Vivotek
Model	IB8360-W
Category	Security Camera
Language	English