Vivotek MD8562 - Fine-Tune the Camera Focus

EN - 10
Attach the dome cover to camera. Secure
the dome screws with the supplied
screwdriver. Finally, make sure all parts of
the camera are securely installed.
Completion
8
Fine-tune the Camera Focus
The focus of this network camera is set from 1.0 meter to innity by factory default. If you want to
focus on objects closer than 1.0m or the lens has lost focus, please ne tune it in the following way.
Loosen the lens lock screw.
1. Loosen the lens lock screw under the lens
module.
2. Manually rotate the lens to ne-tune the focus
until the live image is clear.
3. Tighten the lens lock screw.
Tear down the aluminum foil vacuum bag and
take out the moisture absorber. Attach the
supplied moisture absorber to the inner side of
the dome cover. (Please replace the absorber
whenever you open the dome cover.)
IMPORTANT!
Please secure the screws
tightly to avoid moisture.