Vivotek MD8562 - Digital I;O and Tampering Detection; Tampering Detection Setup

VIVOTEK
94 - User's Manual
Applications - DI and DO
Advanced Mode
Digital input: Select High or Low to dene the activate status for the digital input. The Network Camera's
current status is shown on the right.
Set up the event source as DI on Event > Event settings > Trigger. Please refer to page 90 for detailed
information.
Applications - Tampering detection
This section explains how to set up camera tamper detection. With tamper detection, the
camera is capable of detecting incidents such as redirection, blocking or defocusing, or even
spray paint.
Please follow the steps below to set up the camera tamper detection function:
1. Check Enable camera tampering detection.
2. Enter the tamper trigger duration. (10 sec. ~ 10 min.) The tamper alarm will be triggered only when the
tampering factor (the difference between current frame and pre-saved background) exceeds the
trigger threshold.
3. Set up the event source as Camera Tampering Detection on Event > Event settings > Trigger.
Please refer to page 90 for detailed information.