EasyManua.ls Logo

Vivotek MS8391-EV - Page 169

Vivotek MS8391-EV
235 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
VIVOTEK
User's Manual - 169
URL Command Document for All Series391
33
bgain
0~100
21
4/4
Manual set bgain value of
gain control setting.
sensormode
panorama,
region,
panorama
4/4
panorama” indicates that
camera would try to balance
the image effect of every
sensor.
region indicates that the
image effect of every sensor
is independent to each other.
Note: Only available when
capability_videoin_c0_nsensor
> 1.
7.9 IR cut control
Group: ircutcontrol
NAME
VA L U E
DEFAULT
SECURITY
(get/set)
DESCRIPTION
mode
auto,
day,
night,
di,
schedule
auto
6/6
Set IR cut control mode
sir
<boolean>
0
6/6
Enable/disable Smart IR
daymodebegintime
00:00~23:59
07:00
6/6
Day mode begin time
daymodeendtime
00:00~23:59
18:00
6/6
Day mod end time
disableirled
<boolean>
0
6/6
Enable/disable built-in IR led
bwmode
<boolean>
1
6/6
Switch to B/W in night mode if
enabled
sensitivity
low,
normal,
high
normal
6/6
Sensitivity of light sensor
URL Command Document for All Series391
34
7.10 image setting per channel
Group: image_c<0~(n-1)> for n channel products
NAME VA L U E DEFAULT SECURITY
(get/set)
DESCRIPTION
brightness
-5 ~ 5 0 4/4 Adjust brightness of
image according to
mode settings.
saturation -5 ~ 5, 100 100 4/4 Adjust saturation of
image according to
mode settings.
saturationpercent 0~100 50 4/4 Adjust saturation
value of percentage
when saturation=100
contrast -5 ~ 5 0 4/4 Adjust contrast of image
according to mode
settings.
sharpness -3 ~ 3, 100 100 4/4 Adjust sharpness of
image according to
mode settings.
sharpnesspercent 0~100 50 4/4 Adjust sharpness of
image by percentage.
Softer 0 <-> 100
Sharper
gammacurve 0~100 0 4/4 Gamma curve.
dnr_mode 0~1 1 4/4 3D noise reduction.
0: off
1: on
dnr_strength 1~100 50 4/4 3D noise reduction
strength.
profile_i0_enable <boolean> 0 4/4 Enable/disable this
profile setting
profile_i0_policy day,
night,
schedule
night 4/4 The mode which the
profile is applied to.
profile_i0_begintime hh:mm 18:00 4/4 Begin time of
schedule mode.
profile_i0_endtime hh:mm 06:00 4/4 End time of schedule

Table of Contents

Related product manuals