Vivreau VI TAP - Operating Instructions Overview; LED Display Panel; Dispensing Operations

A
OPERATING INSTRUCTIONS
LED DISPLAY
The LED Display Panel is located on the front panel of the Chiller/Carbonator.
The Vi Tap Dispensing System has been designed for ease of use
.
IMPORTANT _________________________
Before operating the ViTAP Dispensing System, make
sure the water supply is turned ON and the unit is
plugged in.
BEFORE USE
ALWAYS sanitize your hands.
ALWAYS wear hygienic gloves.
ALWAYSremoveanti-bacterialclinglmfromthe
Dispensing Head.
ALWAYS wipe Dispensing Head, Nozzles, Drip Tray
and cabinet work-surface with anti-bacterial wipes.
Dispensing Head System LED Display Panel
POWER: When the Dispensing Head System is plugged in and turned ON, a Blue LED
will be illuminated.
CHANGE CO2: When the CO2 supply is low, a Red LED will illuminate and the unit will
beep; alerting you to change the CO2 Cylinder.
CALL SERVICE: If there is a problem, a Red LED will illuminate and the unit will beep.
Please contact Vivreau Service Toll-Free at 877-999-1044 immediately.
EMPTY DRIP TRAY: (Not Activated on this Unit)
DISPENSING
IMPORTANT _________________________
Before operating the ViTap Dispensing System, make sure the Water Supply Valve is
open and the unit is plugged in.
DISPENSING:
Place appropriate container on Drip Tray beneath the Dispensing Head.
Chilled Still Water
Press and Hold the Blue Button to dispense water.
Releasethebuttonwhenlled.