English - ii
IMPORTANT SAFETY INSTRUCTIONS
Your Display is designed and manufactured to operate within dened
design limits. Misuse may result in electric shock or re. To prevent
your Display from being damaged, the following instructions should be
observed for the installation, use, and maintenance of your Display. Read
the following safety instructions before operating your Display. Keep these
instructions in a safe place for future reference.
• To reduce the risk of electric shock or component damage, switch o the
power before connecting other components to your Display.
• Read these instructions.
• Keep these instructions.
• Heed all warnings.
• Follow all instructions.
• Do not use this Display near water.
• Clean only with dry cloth.
• Do not block any ventilation openings. Install in accordance with the
manufacturer’s instructions.
• Do not install near any heat sources such as radiators, heat registers, stoves,
or other apparatus (including ampliers) that produce heat.
• Do not defeat the safety purpose of the polarized or grounding-type plug. A
polarized plug has two blades with one wider than the other. A grounding
type plug has two blades and a third grounding prong. The wide blade or
the third prong are provided for your safety. If the provided plug does not t
into your outlet, consult an electrician for replacement of the obsolete outlet.
• Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the Display.
• Only use attachments/accessories specied by the manufacturer.
• Use only with the cart, stand, tripod, bracket, or table specied by the
manufacturer, or sold with the Display. When a cart is used, use caution
when moving the cart/Display combination to avoid injury from tip-over.
• Unplug this Display during lightning storms or when unused for
long periods of time.
• Refer all servicing to qualied service personnel. Servicing is
required when the Display has been damaged in any way, such as
power-supply cord or plug is damaged, liquid has been spilled or
objects have fallen into the Display, the Display has been exposed to rain or
moisture, does not operate normally, or has been dropped.
• Unplug the power cord before cleaning your Display.
• When moving your Display from an area of low temperature to an area
of high temperature, condensation may form in the housing. Wait before
turning on your Display to avoid causing re, electric shock, or component
damage.
• A distance of at least three feet should be maintained between your Display
and any heat source, such as a radiator, heater, oven, amplier etc. Do not
install your Display close to smoke. Operating your Display close to smoke or
moisture may cause re or electric shock.
• Slots and openings in the back and bottom of the cabinet are provided for
ventilation. To ensure reliable operation of your Display and to protect it
from overheating, be sure these openings are not blocked or covered. Do
not place your Display in a bookcase or cabinet unless proper ventilation
is provided.
• Never push any object into the slots and openings on your Display cabinet.
Do not place any objects on the top of your Display. Doing so could short
circuit parts causing a re or electric shock. Never spill liquids on your
Display.
• Your Display should be operated only from the type of power source
indicated on the label. If you are not sure of the type of power supplied to
your home, consult your dealer or local power company.
• Do not apply pressure or throw objects at your Display. This may compromise
the integrity of the Display. The manufacturer’s warranty does not cover user
abuse or improper installations.
• The power cord must be replaced when using dierent voltage than the
voltage specied. For more information, contact your dealer.
• When connected to a power outlet, power is always owing into your
Display. To totally disconnect power, unplug the power cord.
• Do not overload power strips and extension cords. Overloading can result
in re or electric shock.
• Use only with the UL-listed wall mount bracket rate for the weight/load of
the display.
• The wall socket should be installed near your Display and easily accessible.
• Only power of the marked voltage can be used for your Display. Any other
voltage than the specied voltage may cause re or electric shock.
• Do not touch the power cord during lightning. To avoid electric shock, avoid
handling the power cord during electrical storms.
• Unplug your Display during a lightning storm or when it will not be used
for long period of time. This will protect your Display from damage due to
power surges.
• Do not attempt to repair or service your Display yourself. Opening or
Safety Information
To Next Page
Loading...
Need help?
General
