SELECTION OF LOCK FOR VIZIT-KTM600F
VIZIT-KTM600F
Electromagnetic lock
VIZIT
IMPORTANT.
DO NOT use electromagnetic locks with resistance less than 20 Ohms, and not provided with a built-in degaussing
module.
Basic types of electric strikes, solenoid locks
Fail-locked (Fail-secure)
Note. VIZIT-KTM600F
The RF controller allows operation with different types of locks, such as electromagnetic locks, various
electric strikes, electromechanical solenoid locks.
The lock is blocked as long as the power is switched on. Once the current is switched off
or interrupted due to power failure, the lock is released and the door can be opened.
Recommended: electromagnetic locks ® with a built-in degaussing module, in combination with door closers
-
The RF controller does not support use of motor locks.
.
The strike / lock is blocked as long as the power is switched off. Once the voltage is switched
on, the strike / lock is released and the door can be opened.
Recommended: fail-locked strikes / solenoid locks with supply voltage 12 VDC and current consumption up to A.
-
The strike / lock is unblocked after a short power impulse, and remains
unblocked, even when the power is off. Once the door is opened and then
closed again, the strike / lock will resume its normal operation, and will be
blocked again.
Recommended: fail-locked strikes / solenoid locks with supply voltage 12 VDC and current consumption up to 1 A.
-
The strike / lock is blocked as long as the power is switched on. Once the voltage is switched
off or interrupted due to power failure, the strike / lock is released and the door can be opened.
Recommended: fail-unlocked strikes / solenoid locks with supply voltage 12 VDC and current consumption up to 0.6 A.
Fail-locked with hold-open function
Fail-unlocked (Fail-safe)
1
www. 5VIZIT-KTM600F Operating Instruction (revision 10)vizit-group.com 4 11/201 -
To Next Page
Loading...
