Courtesy of Main Resource, Inc. Visit us at www.MainResource.com or call 800 362-6740 for all
your telecom needs.
Call Park
Call Park allows an agent to put a caller while a page announcement is made or an internal party
called.
While connected to an outside calls:
1. Press TRANS.
2. Dial park location (430-437). If a busy tone sounds, press TRANS twice and try another
location.
Pick up a Parked call:
1. Lift the handset or press ON/OFF.
2. Press the # button.
3. Dial the location of the parked call.
Call Pick Up:
If a call is ringing at an unattended telephone in your group:
1. Lift the handset.
2. Dial #0 or press the pre-programmed PICK UP button to connect.
Voice Mail (Requires Optional Software)
Retrieve Voice Mail Messages:
1. Dial the voice mail group number, programmed voice mail group button or flashing Message Wait button.
2. Enter your password.
Transfer a Caller to Voice Mail
Use when a station is not forwarded to voice mail and a caller wishes to be sent directly to voice mail.
1. While on a call, press the TRANS button.
2. Dial the Voice Mail Group number or the programmed VM group button
3. Dial the mail box location of the party and go on-hook.
Setting User Preferences
Distinctive Ring
The system allows for up to 81 ring patterns that each user may select from.
1. Dial 695.
2. Enter the two-digit tone number 01-88 (88 for no ring). The corresponding ring will sound.
3. When you hear the tone you want, press the SPEED button.
Speed Dial
To Use:
3. Press the SPEED button
4. Dial the bin location or press the programmed speed bin button (00-19 for station speed and
20-99 for system speed dial).
Store Speed Numbers (System speed dial numbers must be programmed by the attendant station or station 100 if
no attendant station is assigned):
7. Press the SPEED button
8. Press a desired outside line or pool button or SPEED again to select an outside line automatically.
9. Dial the speed bin location (00-19 for station speed and 20-99 for system speed dial).
10. Dial the telephone number. Pressing HOLD during number entry adds a pause. FLASH inserts a flash.
11. Press SPEED to end, or
12. Press SPEED twice to finish programming the number and enter a new number.
To erase a speed button:
3. Press the SPEED button twice
4. Dial the speed bin location (00-19 for station speed and 20-99 for system speed dial).
5. Press SPEED again.
To Next Page
Loading...
