Courtesy of Main Resource, Inc. Visit us at www.MainResource.com or call 800 362-6740 for all
your telecom needs.
2. Use silent text messaging (only available when both parties have a display terminal) by
pressing a pre-programmed message button (shown below) without leaving the current call.
For example, pressing the pre-programmed “IN MEETING” key will display that message on
the calling stations’ LCD display.
[31] = I WILL TAKE CALL
[32] = TAKE MESSAGE
[33] = TRANSFER TO SECRETARY
[34] = PUT CALL ON HOLD
[35] = CALL BACK
[36] = ONE MOMENT PLEASE
[37] = I WILL CALL BACK
[38] = WHO IS IT?
[39] = IS IT LONG DISTANCE?
[40]= IS IT PERSONAL?
[41] = IS IT AN EMERGENCY?
[42] = IS IT IMPORTANT?
[43] = IS IT URGENT?
[44] = SEND CALL TO VOCCE MAIL
[45] = PARK CALL
[46] = OUT OF OFFICE
[47] = PUT CALL THROUGH
[48]= I AM BUSY
[49] = O.K.
[50] = NO
[51] =YES
Flexible Button Assignment:
Buttons on your telephone that have not been assigned as CO lines, pooled group or loop buttons,
you may program them as desired.
There are five possible functions
You may assign to these buttons:
• DSS/BLF: This button when pressed, will automatically signal the assigned intercom station.
The station user programs DSS/BLF buttons.
• FEATURES: A shortcut for dialing feature codes. The station user programs feature buttons.
• SPEED DIAL: A one-touch method to dial programmed locations.
• POOLED GROUP ACCESS: Several outside lines may be placed on this one button. When it is
selected, the system chooses an available line from this group. The database administrator
assigns these buttons.
• LOOP: Any telephone that does not display all outside lines must have a LOOP button, which
will display these outside lines. LOOP buttons are assigned in database administration.
To Program flexible buttons:
1. Press SPEED twice.
2. Press the button to be programmed (must have been programmed in the database as a
multifunction button).
3. Dial the desired code, referring to the table below.
To Next Page
Loading...
