Courtesy of Main Resource, Inc. Visit us at www.MainResource.com or call 800 362-6740 for all
your telecom needs.
2. Press the “#” key. The system will select the outside line last used (if available) and will dial
the last number dialed. If no lines are available in the same group, the station user will get
a busy tone and can queue for a line. If a line is preselected, the preselect overrides the
selection of the line used for the original call.
Place a Call Using Least Cost Routing (Requires optional software):
To place an outside call when LCR has been enabled, dial “9” before the number. If all lines are
busy, remain off-hook for four second to be queued for an available line. To cancel a callback
request, dial “626”. Replace the handset or press the ON/OFF button.
Message Waiting
Use message waiting to leave a message at a station that is busy, unattended or in DND.
1. Lift the handset.
2. Dial the station.
3. When the busy tone sounds, press the pre-programmed MSG button. The called party’s MSB
button will flash.
4. Hang up to end.
Saved Number Redial
To save, after placing an outside call, do not go back on-hook. Press SPEED twice before hanging
up. To use, press SPEED and *.
Speed Dial
To Use:
1. Press the SPEED button
2. Dial the bin location or press the programmed speed bin button (00-19 for station speed and
20-99 for system speed dial).
Store Speed Numbers (System speed dial numbers must be programmed by the attendant station or station 100 if
no attendant station is assigned):
1. Press the SPEED button
2. Press a desired outside line or pool button or SPEED again to select an outside line automatically.
3. Dial the speed bin location (00-19 for station speed and 20-99 for system speed dial).
4. Dial the telephone number. Pressing HOLD during number entry adds a pause. FLASH inserts a flash.
5. Press SPEED to end, or
6. Press SPEED twice to finish programming the number and enter a new number.
To erase a speed button:
1. Press the SPEED button twice
2. Dial the speed bin location (00-19 for station speed and 20-99 for system speed dial).
Press SPEED again.
Paging
1. Lift the handset or press ON/OFF
2. Dial the two or three-digit paging code or the pre-programmed PAGE button.
• 70=All Call Internal and External
• 71=Internal Zone 1
• 72=Internal Zone 2
• 73=Internal Zone 3
• 74=Internal Zone 4
• 75=Internal All Call
• 760=External All Call
• 76Z=External Zones 1-7
3. Announce the page
To Next Page
Loading...
