1
·Outlet the oil：
–In case too high the oil level, please remove the oil drainage bolt by socket wrench，the oil drainage bolts are at the
middle place of engine bottom (Picture 1) and left side of tail (Picture 2).
–Outlet some oil then re-assemble the oil drainage bolt. Too high or low the oil level may both damage the engine
Please make sure the oil is at a correct level.
The oil may expand with temperature rise, so its level also changes.
The hotter the engine the higher the oil level, while the colder engine
with lower oil level, which both are normal.
Keep the motorcycle upright when checking the oil level, in another
word is vertical to the ground.
!
Caution
46
Figure 1
Figure 2
The oil drainage bolt is near the muffler, please drain
the oil off when the bolt and muffler basically cooled
down, when draining the oil, protect yourself from hot
oil to avoid scald.
!
Danger
To Next Page
Loading...
