Vogelsang VX186QD - Page 5

Table of contents
WBV.PU.002.EN VX186QD V2.0
5
Table of figures
Fig. 1: Flow direction with InjectionSystem...................................................................................................... 13
Fig. 2: Name plate ........................................................................................................................................... 14
Fig. 3: Positions of the warning and safety labels ........................................................................................... 19
Fig. 4: Transport aids ....................................................................................................................................... 20
Fig. 5: Installation variants ............................................................................................................................... 22
Fig. 6: Long suction lines ................................................................................................................................. 24
Fig. 7: Flow direction with motor drive ............................................................................................................. 25
Fig. 8: Flow direction with PTO drive ............................................................................................................... 25
Fig. 9: Flow direction with pump units ............................................................................................................. 26
Fig. 10: Tightening sequence .......................................................................................................................... 27
Fig. 11: Orientation procedure ......................................................................................................................... 29
Fig. 12: Coupling guard ................................................................................................................................... 30
Fig. 13: Vent screw on the gearbox (removing the seal) ................................................................................. 33
Fig. 14: Buffer fluid tank ................................................................................................................................... 42
Fig. 15: Filling/draining the buffer chamber ..................................................................................................... 43
Fig. 16: Pump with quenching fluid tank .......................................................................................................... 45
Fig. 17: Pump with pressure valve .................................................................................................................. 46
Fig. 18: Installation example - dry buffer chamber .......................................................................................... 49
Fig. 19: Flushing operation .............................................................................................................................. 50
Fig. 20: Gear oil change .................................................................................................................................. 52
Fig. 21: Opening/closing the QD cover ............................................................................................................ 58
Fig. 22: des Opening the QD cover with double hinge .................................................................................... 59
Fig. 23: Rotary lobe change............................................................................................................................. 60
Fig. 24: HiFlo and HiFloplus arrangement ....................................................................................................... 61
Fig. 25: Lobe puller components ..................................................................................................................... 62
Fig. 26: Hooking puller arm into lobe ............................................................................................................... 63
Fig. 27: Pulling out the lobes with lobe puller .................................................................................................. 63
Fig. 28: Installation position of the curved wear plates .................................................................................... 64
Fig. 29: Cartridge mechanical seal on the gearbox ......................................................................................... 66
Fig. 30: Cartridge mechanical seal change on the QD cover .......................................................................... 68
Fig. 31: Cleaning before QD cover assembly .................................................................................................. 69
Fig. 32: Adjustment of pump housing segments ............................................................................................. 70
Relevant documents
• Dimension sheet / drawing
• Characteristic line
• EC declaration of conformity
Optional:
• Technical information on drive system
• Technical information on safety devices
Please read and adhere to the information and instructions in the relevant documents.