11
4-2 Rear Panel
Triggering:
(24)EXT TRIG IN Input Terminal
Input Terminal is used for external triggering signal by setting SOURCE switch (23) to the EXT position.
(34)Z AXIS INPUT
Input terminal for external intensity modulation signal.
(35)CH1 SIGNAL OUTPUT
Delivers a voltage of approximately 20mV/DIV from the CH1 signal to 50Ω terminal for frequency counting.
AC POWER Input Circuit:
(36)AC Power input connector
Connect the AC power cord (supplied) to this connector.
(37)FUSE & line voltage selector
Fuse rating is shown in Page 7 Line voltage selector to select power sources.
(38)Studs
Studs is not only used as a stand for laying the oscilloscope on its back to operate it in the upward posture, also
used for winding up the power cord.
To Next Page
Loading...
