To Next PageTo Next PageWhat to do if my VOLTCRAFT Test Equipment shows no change in measured value?
If the VOLTCRAFT Test Equipment shows no change in measured value, check the following: * Ensure the correct measuring function (AC/DC) is active and switch if necessary. * Verify the measuring leads are correctly plugged into the measuring sockets. * Deactivate the hold function by pressing the "HOLD" button if the "H" is displayed. * Check the fuse.
Why is no insulation measurement possible with my VOLTCRAFT Test Equipment?
If your VOLTCRAFT Test Equipment is unable to perform insulation measurements, ensure that there is no external voltage present at the measuring leads. Turn off power to all circuit components.
What to do if my VOLTCRAFT ET-200 can't perform low-ohm resistance measurement?
If your VOLTCRAFT Test Equipment cannot measure low-ohm resistance, make sure there's no external voltage at the measuring leads. Turn off power to all circuit components.
General| Brand | VOLTCRAFT |
|---|---|
| Model | ET-200 |
| Category | Test Equipment |
| Language | English |
General safety rules for handling the device, environment, and personal safety.
Specific safety measures for performing measurements correctly and avoiding electrical hazards.
Safety rules for handling, storing, and disposing of batteries.
Defines common indicators and abbreviations seen on the device's screen.
Critical safety warnings and guidelines applicable before and during any measurement.
Detailed steps for conducting insulation resistance tests with auxiliary voltage and safety considerations.
A guide to identifying and resolving typical errors, causes, and remedies.
Accuracy details for insulation resistance tests at various nominal output voltages.
