18
b) Power adaptor
• The mains outlet must be located near to the device and be easily accessible.
• As power supply, only use the supplied mains adaptor.
• Only connect the power adaptor to a normal mains socket connected to the public supply. Before plug-
ging in the power adaptor, check whether the voltage stated on the power adaptor complies with the
voltage of your electricity supplier.
• Never connect or disconnect power adaptors if your hands are wet.
• Neverunplugthepoweradaptorfromthemainssocketbypullingonthecable;alwaysusethegrips
on the plug.
• When setting up the product, make sure that the cable is not pinched, kinked or damaged by sharp
edges.
• Always lay the cables so that nobody can trip over or become entangled in them. This poses a risk of
injury.
• For safety reasons, disconnect the power adaptor from the mains socket during storms.
c) Charger
• This charger only works with Ni-Mh, Ni-Cd, LiFePO4, and Li-ion type batteries. Never use the charger
with other types of batteries as this could result in explosion, cracking or leaking causing damage to
property and/or personal injury.
• Never use the product immediately after it has been brought from a cold room into a warm one. The
condensation generated could destroy the product. Allow the product to reach room temperature before
connecting it and putting it to use. This may take several hours.
• When the charger is not in use, disconnect it from the power supply and remove any batteries from the
charging slots.
• The battery data displayed on the LCD is for reference only and may differ from those measured with
professional equipment.
To Next Page
Loading...
Need help?
General
