Designation of component parts
1. Temperature plunge feeler 9. Battery
2. LCD display compartment lid
3. ON/OFF key 10. Battery
4. MIN/MAX key compartment
5. H/T (Hold/Temperature) key 11. Cable
6. HI AL key (Upper alarm level) compartment
7. °F / °C key 12. Tiltable stand
8. LO AL key (Lower alarm level)
18
To set the alarm levels, press the respective key (HI AL
or LO AL) and keep it depressed until the alarm level
desired is shown in the LCD (2). The LCD (2) displays
"HI" or "LOW" to indicate that an alarm level is set.
Note that the LO level may not be higher than the HI
level.
To delete the alarm levels, briefly turn the instrument off
and on again.
Maintenance and care
Only use a soft, dry cleaning cloth to clean the instru-
ment externally. Never use any cleansing agents.
Maintenance or repair should only be performed by
expert personnel who are conversant with the relevant
instructions.
Disposal
Dispose of the instrument, which has become unservi-
ceable because of a defect, in conformity with the cur-
rent legal provisions.
23
To Next Page
Loading...
Need help?
General
