VPA 7748089 English 09-2007 49
Engine — 5.0 & 5.7 Litre
5. Install the intake manifold assembly onto the engine block.
6. If reusing the fasteners, apply threadlock Volvo Penta P/N
1161053 or equivalent to the threads of the manifold bolts.
7. Install the manifold bolts.
Tighten: NOTICE! Proper lower intake manifold fastener tightening se-
quence and torque is critical. Always follow the tight-
ening sequence, and torque the intake manifold bolts
using the 3 step method. Failing to do so may distort
the crankshaft bearing bore alignment and cause
damage to the crankshaft bearings.
8. Tighten the intake manifold bolts.
a. Tighten the bolts in sequence (1-8) on the first pass to 3
N•m (27 lb. in).
b. Tighten the bolts in sequence (1-8) on the first pass to 12
N•m (106 lb. in).
c. Tighten the bolts in sequence (1-8) on the first pass to 15
N•m (11 lb. ft.).
9. Connect fuel lines to fuel rail. See Quick Connect Fitting Ser-
vice on page 346 of EFI Diagnostic Workshop Manual
7742218.
Distributor Installation Install distributor with rotor and aligned exactly as marked during re-
moval.
NOTICE! If the crankshaft was moved while distributor was out,
complete ignition timing procedure must be followed.
See below.
To Next Page
Loading...
Need help?
General
