Instruments
Fuel tank calibration
There are two possible calibration methods for the fuel tank. One approximative, FULL TANK CALIBRATION,
and one more precise, FUEL MULTIPOINT CALIBRATION. A fuel level sender need to be installed.
NOTE! If FUEL TANK CALIBRATION is not shown in SETTINGS MENU, please contact your Volvo Penta dealer.
FUEL MULTIPOINT CALIBRATION
When FUEL MULTIPOINT CALIBRATION is select-
ed, the fuel level sender is calibrated in five equally
divided steps; 20% full (pos 1), 40% full (pos 2), 60%
full (pos 3), 80% full (pos 4) and 100% full (pos 5)
NOTE! To perform multipoint calibration, fuel tankTo perform multipoint calibration, fuel tank
must be LESS than 20% full. If calibration skips POS
1 and goes directly to POS 2, the fuel tank contains
to much fuel and the calibration will not be correct.
1. Activate helm station by pushing the ACTIVA-
TION BUTTON.
2. Select SETTINGS from MAIN MENU by turn-
ing NAVIGATION WHEEL. Push NAVIGATION
WHEEL to enter SETTINGS MENU.
3. Select FUEL TANK CALIBRATION and push
NAVIGATION WHEEL.
4. Select FUEL MULTIPOINT CALIBRATION by
turning NAVIGATION WHEEL. Push NAVIGA-
TION WHEEL to enter FUEL MULTIPOINT CALI-
BRATION.
NOTE! The fuel multipoint calibration procedure dif-
fers depending on EVC software release.
5A. If the number after “POS” in the display is flashing:
Fill fuel tank with displayed volume (POS 1) and
push NAVIGATION WHEEL. Add fuel (do not reset
the pump) up to displayed volume for each POS
until the tank i filled.
Push BACK BUTTON to return to SETTINGS MENU.
5B. If the number after “POS” is not flashing:
Fill fuel tank with displayed volume (POS 1) and
push NAVIGATION WHEEL. Repeat procedure
for each POS until the tank is filled.
Push BACK BUTTON to return to SETTINGS MENU.
To Next Page