Instruments and Controls
This chapter describes the instruments, panels and controls Volvo Penta sells for your engine.
If you would like to complement your instrumentation, or if your boat is equipped with instruments not described
here, we ask that you contact your Volvo Penta dealer.
Ignition Lock
The start keys are supplied with a plate bearing the
start code
to be used when ordering spare keys. Keep
the code beyond the reach of unauthorized people.
S = The stop position.
0 = The key can be inserted or removed.
I = Operating position. System power is connected.
II = Not used.
III = Start position. Starter motor is engaged.
There is always a main helm station on a boat. It is the
only helm station with an ignition lock. The ignition
must be switched on here in order for other helm sta-
tions to be used.
Read the starting instructions in the Start-
ing page 44
chapter to make sure you use the correct
start procedure.
Control Panels
Volvo Penta panels and gauges can be installed in dif-
ferent combinations. There is always one information
panel per driveline and helm station if no 7" screen is
installed. The control panels can be used together with
the tachometer and other accessory equipment.
10 47702599 12-2011
47702599 - Downloaded from www.volvopenta.com 23/11/2015 22:01:35
To Next Page
Loading...
