7
The warning triangle lights up if the system discov-
ers a fault; refer to Fault Handling page 58 for
information.
The
warning triangle lights up on the same side as
the driveline with the indicated fault. In triple instal-
lations, both triangles light up if the center driveline
registers a fault.
8 This function is not available.
Disengaging the Shift Function
The gearshift function can be disconnected so that the
control lever only operates the throttle.
1 Put the control levers in neutral.
2 Press the control “Throttle Only” button or the neu-
tral button (N) on the helm station panel.
3 Release the button. The N symbol on the control
will light up as confirmation that the gearshift func-
tion is disengaged and that the lever will only affect
engine revolutions.
To exit neutral mode, press the button again.
STATION
Throttle
only
CRUISE
CONTROL
SINGLE
LEVER
LOW
SPEED
P0012475
Instruments and Controls
32 47702095 04-2011
To Next Page
Loading...
