Engine, General
General inspection
Make a habit of visually checking the engine and
engine bay before starting, and after operations when
you have
stopped the engine. This will help you to dis-
cover abnormalities quickly, or if something is about to
happen.
Look especially carefully for oil, fuel and coolant lea-
kages, loose bolts, worn or poorly-tensioned drive
belts, loose cable connections, damaged electrical
cables and hoses. This inspection only takes a few
minutes and can prevent serious malfunctions and
expensive repairs.
WARNING!
Accumulations of
fuel, oil and grease on the engine or
in the engine room is a fire hazard and must be
removed immediately they are detected.
WARNING!
If an oil, fuel or coolant leak is detected, the cause must
be investigated and the fault rectified before the engine
is started.
Never direct the jet from a high-pressure washer at
seals, rubber hoses or electrical components. Never
use the high pressure setting for engine cleaning.
Air Filter, Check and Change
1 Remove the old filter cartridges. Make sure that no
contaminants enter the engine.
2 Install new filter cartridges. Tighten the hose
clamps carefully.
IMPORTANT!
Discard the old filter cartridges. They may not be
cleaned.
Maintenance
47702095 04-2011 75
To Next Page
Loading...
