Lubrication System
Oil change intervals can vary depending on oil grade
and sulphur
content of the fuel, please refer toTechni-
cal Data, Lubrication System.
Oil change intervals must never exceed a period of 12
months.
If you want longer oil change intervals than given in the
table Oil Grade and Oil Change Interval, the condition
of the oil must be checked by the oil manufacturers
through regular oil testing.
Oil level, checking and topping up
The oil level must be inside the marked area on the
dipstick and should be checked daily before the first
start.
When checking the oil level; take the oil dipstick out
and wipe it. Put it back and remove it again to read the
oil level.
IMPORTANT!
Do not fill up above the maximum oil level. Only use a
recommended grade of oil, please refer to section
Technical Data, Lubrication System.
1 Top up the oil through the filling hole at the back of
the engine (1).
2 Wait 15 minutes after topping up to allow the oil time
to reach the sump before checking the level again.
3 Check the level again.
Maintenance
78 47702095 04-2011
To Next Page
Loading...
