Oil Filter/By-pass Filter, Change
Change the oil filter and bypass filter during each oil
change.
Remember to
hand the old filters in to a re-cycling sta-
tion.
WARNING!
Hot oil and hot surfaces can cause burns.
1 Put a
suitable vessel underneath the filters to avoid
oil spillage.
2 Clean the filter bracket.
3 Unscrew the bypass filter (1) and the oil filters (2)
with a suitable extractor.
4 Check that the mating surfaces on the filter brack-
ets are clean, and that no residue from the old seals
remains.
5 Moisten the seals on the new filters with engine oil.
6 Screw the filters on by hand until the rubber seals
just touch the mating surface on the filter brackets.
Then tighten a further 3/4 to 1 turn.
7 Start the engine (low idle) and check that no leak-
age occurs. Check the oil level once the engine has
stopped.
Maintenance
80 47702095 04-2011
To Next Page
Loading...
