34
Maintenance: Lubricating system
Electric oil bilge pump (accessory)
Take out the dipstick and undo the disptick pipe. Turn
the pipe over and insert it into the oil sump. Connect
the suction line to the pipe and pump out the oil. Turn
off the pump. Refit the dipstick pipe and the dipstick.
The pump can also be used for filling oil by switching
over the + and - lines on the pump.
Changing engine oil
1. Run the engine warm.
2. Stop the engine. Pump out the oil and collect it in
a receptacle.
WARNING! Hot oil and hot surfaces can cause
burns.
3. Change oil filter as directed on the next page.
4. Refill oil to the correct level (See “Technical data”
for oil volume).
5. Start engine and the on.
6. Check that the warning lamp for low oil pressure
goes out and the filter is not leaking.
IMPORTANT! Always follow the recommended
oil change interval.
7. Stop the engine. Wait a few minutes. Check the oil
level. Top up if needed.
NOTE! Leave the old oil to a destruction plant.
To Next Page
Loading...
