19
3. Move the lever to the wide open throttle (WOT)
position ahead (forward) movement. Hold the le-
ver in this position.
Acknowledge the position by pressing in the
green button for at least three seconds.
4. Move the control lever to the position where
astern gear is engaged. Hold the lever in this
position.
Acknowledge the position by pressing in the
green button for at least three seconds.
5. Move the lever to the wide open throttle (WOT)
astern position. Hold lever in this position.
Acknowledge the position by pressing in the
green button for at least three seconds.
6. Return the lever to the Neutral position. Hold the
lever in this position.
Acknowledge the position by pressing in the
green button for at least three seconds.
7. Finish calibration by pressing down the green
button again (the yellow and green buttons then
stop flashing).
TAMD73P and TAMD74: EDC control panel –
Single engine
TAMD73P and TAMD74: EDC control panel –
Single engine
Throttle potentiometer bracket when using
mechanical control
A. Control cable movement (throw)
Calibrating mechanical single lever
control
NOTE! Certain other makes of control have been
shown to have greater travel (A) with full throttle
opening with the reverse gear disengaged than
with wide open throttle (WOT) with the reverse
gear engaged.
Measure the movement (A) at the potentiometer
bracket at wide open throttle (WOT) and with the
reverse gear engaged. Note the result.
NOTE! Calibrate first at the Master Control Sta-
tion followed by the other control stations(s).
1. Set the EDC system to calibration mode accord-
ing to instructions in “Preparations” (see page 18).
2. Press in the button (2) on the control unit (to dis-
engage gearshift function – see illustration on
page 16). At the same time move the lever for-
ward to wide open throttle (WOT) position. Hold
the lever in this position.
Acknowledge the position by pressing in the
green button (Neutral) for at least 3 seconds.
Single lever control from other manufactur-
ers: Disengage the shift function and at the same
time move the lever forward to WOT position.
Hold the lever in this position.
NOTE! Check that the control cable movement
does not exceed the value noted earlier.
Acknowledge the position by pressing in the
green button for at least three seconds.
NEUTRAL
NEUTRAL
7740156 - Downloaded from www.volvopenta.com 22/07/2009 00:44:08
To Next Page