123456789012345678901
123456789012345678901
123456789012345678901
123456789012345678901
123456789012345678901
*
*
*
6. Twin Disc reverse gear:
Remove and clean re-
verse gear oil screen.
7. Replace oil filter in re-
verse gear Twin Disc
MG507(A)-1 with trolling
valve and MG5085.
8. Lubricate release bear-
ing on disengageable
clutch (if fitted).
9. Lubricate disengageable
clutch (if fitted).
10. Check/adjust disengage-
able clutch (if fitted).
11. Replace filter(s) for
crankcase ventilation.
* Note. Special recommendations apply for new or reconditioned
engines. See instructions “Running-in” on page 4.
50
–
–
–
–
45
Remove plug and oil screen. Clean screen and reinstall components removed.
Start engine (after filling with oil) and check for leaks.
Rockford/BW
A. P.
Remove clamp (1). Remove cover and take out filter. Clean filter holder and install
new filter. Check oil level (point 3 above).
Note. Every 50 hours, applies when clutch operations per day exceed 15–20 op-
erations. Otherwise every 500 hours. Use grease sparingly so that it is not
pressed out. Use lithium-based lubricating grease: Mobilux EP2, Statoil Uniway
EP2N, Texaco Multifak EP2, Q8 Rembrandt EP2.
Lubricate inner support bearing (when a grease nipple is fitted), main bearings,
disengaging shaft and moving parts of clutch. Lubricate sparingly (20–30 g for
main bearings). Quality: see point 8 above. A few drops of oil on inner link arms.
WARNING! Engine must be stopped when adjustment is carried out.
Remove the inspection cover. Release the catch (A) and turn the adjuster ring (B)
counterclockwise (Rockford/BW), or clockwise (A.P.). Engage the catch. The
clutch plates must not slip after engagement.
Screw on new filter(s) by hand. Note: Replace filter(s) earlier if air and oil mixture
begins to come out of the valve (1).
TAMD71: Check the drain hose (2) is not clogged.
50 Hrs
250 Hrs
500 Hrs
1000 Hrs
2000 Hrs
12 months
No. Operation Instructions Info.
pge.
7740156 - Downloaded from www.volvopenta.com 22/07/2009 00:44:08
To Next Page
Loading...